The 10 Best Resources For

December 29, 2019

Miscellaneous

Comments Off on The 10 Best Resources For


Helpful Hints for Replacing a Cutlass Bearing

The drive shaft log of any vessel has cutlass bearing which is made with brass and a grooved lining from the inside and which is lubricated by the water that penetrates the grooves when it is rotating, this.

It does not matter the number of times that you use your boat, but you must at some point change the cutlass bearing. When it is time to change that cutlass bearing, you will find the cutlass bearing a bit far from the keel or somewhere buried in the woodwork of the boat.

Removing the cutlass bearing is not challenging however your hands will get dirty. These are the steps to follow to replace your boat’s cutlass bearing, now.

Locating and removing the set screws should be the first thing to do. The area where you will find the layer of crud and marine is where the set screws are hidden in most cases. Not all boat manufacturers use the set screws. If you already know that your boat does not have set screws, then it is not good to waste time looking for them.

Cutting the bearing is a must in the replacement of the cutlass bearing. In the absence of a Sawzall, you can use a hacksaw to cut the cutlass bearing. Using the Sawzall tool is something that requires you to have enough experience on how to use it.

The next step of removing a cutlass bearing is by bending it. Using a cold chisel and a hammer it is possible to bend the cutlass bearing to the inner side so that you get to the place where you have made the cut. Do not use excessive force when hitting the cutlass bearing for it to bend. If you force it you will damage the strut of the boat.

Insert a maple dowel after creating a space from bending the cutlass bearing on the boat to the inside and using a hammer slit it open to the other end. Avoid using any tool made of metal to split the cutlass bearing on its length. The interior of the strut may get damaged by so doing.

To conclude, remove the cutlass bearing. Do this with a pair of pliers to hold and remove the bearing. After cleaning the strut’s surface, install a new cutlass bearing. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.

You will damage the strut’s ramrod if you push it and the line it is not straight. For it to go straight use grease on the washers of the cutlass bearing so that it can slide in the strut easily.